Last seen: Aug 14, 2026
That is the right distinction. Calibration is preventive/diagnostic for the camera, while the old clip has to be repaired with whatever valid motion/o...
Exactly. The expensive part of 360 is not just file size; it is the number of framing decisions you postpone to post-production. Use that flexibility ...
Camera calibration normally affects how future motion data is interpreted or captured; it cannot magically rewrite good gyro data into a file that nev...
I moved the virtual camera slightly and the problem became much less obvious, but the real lesson is that the subject was simply too close to the seam...
If you know the final framing and need a fast clip, a pre-framed mode can save a lot of time. The advantage is immediacy. Full 360 capture earns its ...
That seems to be what I have. The rider passes less than half a meter from the camera and the artifact follows that area of the sphere. Would you run...
Understood. I will treat the 360 footage as the master negative, not the 16:9 export. That should also make future square/vertical versions much easie...
What about stitching and orientation? I have had cases where a converted file looked correct but another application no longer understood the horizon ...
For me it is 360 reframing. It moves framing decisions into post and saves missed shots, even though it can add editing time.